Final Stretch of the Semester

For the previous week, I have been working the power point for the next presentation. Will also start to work on the rough draft for the Final Paper.  I have been doing some research no 3D printed parts and seeing what print settings will give me the best outcome.  The chart below shows that I should set my print settings to 70% infill and have a 0.2 mm layer height to account for optimal strength, quality, cost, and speed.  Since quality will not be an issue, printing at an infill of 70% and a layer height of 0.3 mm will also suffice. Research was found from this article: "http://my3dmatter.com/influence-infill-layer-height-pattern/"