Wednesday, March 15, 2017

CAD Design

This week, I worked on revising the bracket to support the posts that will be holding up the solar panels.  The previous design was very bulky and not very aesthetically pleasing to look at. This design was shown in the previous weeks blog. Below is the revisions done for the updated bracket. The middle square tubing is the post that holds up the track. The three outer square tubing are used to support the weight from the solar panel. Not shown in the picture but there is a hole for a set screw to make sure the bracket stays at a fixed height.  The three outer square tubing will be held in by nuts and bolts.

No comments:

Post a Comment